CON-E-CO HRM

• The only horizontal reversing mixer designed and manufactured in the USA
• Significantly lower operating and maintenance costs – no hydraulics
• Lower noise, less wear, extremely reliable, and quiet operation – reversing mixer turns on solid rubber tires
• Control quality on all mix sizes
• Less maintenance and clean-up – virtually dust-free charging and mixing
• Less maintenance and clean-up – splash-free discharge into truck
• Barrel features ¾ inch construction

• Non-tilting discharge
• Rubber tire drive system
• Specifically designed tires
• Sealed inlet end and encapsulated discharge end
• Variable speed drive
• Advanced discharge blade design
• Temperature controlled service panel
• Isolated resistor bank
• Individual drive motor disconnects
• Single phase emergency drive
• Precision jig and fixture manufactured blades and paddles
• Bolt in blades and paddles
• Open slots between the mixing / discharge paddles and drum
• Bolt on removable inlet ring
• 36” retractable inlet chute
• Precision factory drive alignment
• Simple field realignment
• Hot dipped galvanized stairways, ladders, cages, roof railings and conveyor trusses
• Factory check out

PRODUCTION CAPACITY

• Theoretical Cycle Time with 30 second mix time – 2 minutes

BATCHER CAPACITY

• Aggregate – 1 to 12 cubic yards (1 to 9.2 cubic meters)
• Cement – 1 to 12 cubic yards (1 to 9.2 cubic meters)
• Scales – Direct load cells

MIXER CHARGING CONVEYOR

• 48” wide (914 mm), 100 horsepower drive. Optional 54” wide (1,370 mm), 150 horsepower drive

CEMENT II FEEDER SCREWS

• 9” diameter (230 mm), 10 horsepower drive. Optional 12” diameter (300 mm), 15 horsepower drive

CEMENT AERATION

• 5 horsepower, high volume, low pressure blower

HIGH PRESSURE AIR COMPRESSOR

• 20 horsepower, 120 gallon (0.45 cubic meters) receiver. Optional 25 or 30 horsepower

ELECTRICAL

• 460 volt, 3-phase with 120 VAC transformer for control voltage. All motors are TEFC. All motor circuit wiring protected by individual circuit breakers. Electrical components housed in NEMA steel enclosures. Wiring in conduit.

BATCH CONTROL SYSTEM

• Optional fully automatic computerized batch control system.

TRANSPORTATION SYSTEM

• Rear-mounted tandem axle with eight (8) 295/75R 22.5 tires, wheels, air brakes, heavy duty spring suspension, tail and brake lights and fifth wheel rub plate with king pin

STORAGE CAPACITIES

AGGREGATE HEAPED VOLUME

• 60 to 100 cubic yards
• 46 to 76 cubic meters

CEMENT I GROSS VOLUME

• 1,600 to 2,940 cubic feet
• 45 to 83 cubic meters

CEMENT II GROSS VOLUME

• 1,600 to 4,920 cubic feet
• 45 to 83 cubic meters